LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Rail Pressure (FRP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  2. Remove the exhaust gas recirculation (EGR) cooler tube. Refer to Exhaust Gas Recirculation (EGR) Valve Cooler Tube Replacement .
  3. Remove the EGR cooler heat protector bolt (1) and protector (2).
    Fig 1: Removing EGR Cooler Heat Protector
    GM1640993Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the fuel rail pressure sensor electrical connector (4).
  5. Prior to removal, clean the fuel pressure sensor and surrounding area thoroughly with solvent, such as GM P/N 12377981 (Canadian P/N 10953463) or equivalent.
  6. Using compressed air, thoroughly blow dry the sensor and surrounding area.
  7. Remove the fuel pressure sensor (3).
scientia non olet · About LEMON Manuals