LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Rail Fuel Feed Pipe Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Rail Balance Pipe & Bolts
    GM1335586Courtesy of GENERAL MOTORS CORP.
  1. Install the right fuel rail feed pipe.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: View Of Fuel Rail Feed Pipe
    GM1387855Courtesy of GENERAL MOTORS CORP.
  2. Install the fuel rail pipe clamp bolts (2).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  3. Connect the right fuel rail feed pipe fittings (1, 3).

    Tighten:  Tighten the fittings to 41 N.m (30 lb ft).

  4. Install the EGR cooler tube. Refer to Exhaust Gas Recirculation (EGR) Valve Cooler Tube Replacement .
  5. Install the water outlet. Refer to Water Outlet Tube Replacement (6.6L (LLY) Engine) in Engine Cooling.
  6. Install the engine wiring harness. Refer to Engine Wiring Harness Assembly Replacement .
  7. Prime the fuel system. Refer to Fuel System Priming .
  8. Start the engine. If the engine stalls, repeat the above step.
  9. Once the engine starts, inspect for fuel leaks.
scientia non olet · About LEMON Manuals