LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Filler Hose Replacement (Pickup) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the fuel tank filler housing to body screws (1) and retainer (2).
    Fig 1: View Of Fuel Tank Filler Housing To Body Screws & Retainer
    GM853731Courtesy of GENERAL MOTORS CORP.
  2. Remove the fuel tank filler pipe housing to fuel tank fill pipe screws.
    Fig 2: Identifying Fuel Filler Components
    GM300318Courtesy of GENERAL MOTORS CORP.
  3. Remove the fuel tank filler housing.
  4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  5. Remove the fuel tank ground strap bolt (1).
    Fig 3: Removing Fuel Tank Fill Pipe Ground Wire Bolt
    GM1238144Courtesy of GENERAL MOTORS CORP.
  6. Remove the chassis harness ground strap (2) and fuel tank ground strap (3).
    7. Fig 4: View Of Rear Axle Vent Hose
    GM816707Courtesy of GENERAL MOTORS CORP.
  7. Remove the rear axle vent hose from the clip on the fuel fill pipe bracket.
  8. Loosen the fuel tank vent hose and fill hose clamps (1, 2).
    Fig 5: Loosening Fuel Tank Vent Hose And Fill Hose Clamps
    GM1378752Courtesy of GENERAL MOTORS CORP.
  9. Remove the vent hose from the tank.
  10. Remove the fill hose from the tank and the vehicle.
  11. Cap the opening on the fuel tank in order to prevent possible fuel system contamination.
scientia non olet · About LEMON Manuals