LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Lubricate the CMP sensor O-ring with clean engine oil.
  2. Install the CMP sensor.
    Fig 1: Installing Camshaft Position Sensor
    GM1334865Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  4. Install the cooling fan pulley. Refer to Cooling Fan Pulley Replacement (6.6L (LLY) Engine) in Engine Cooling.
scientia non olet · About LEMON Manuals