LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Air Intake Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement in Engine Mechanical - 6.6L (LLY).
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  3. Remove the positive crankcase ventilation (PCV) hose/pipe. Refer to Crankcase Ventilation Hoses/Pipes Replacement in Engine Mechanical - 6.6L (LLY).
  4. Disconnect the turbocharger electrical connector. Lift the metal retainer, in order to disconnect.
  5. Remove the engine wire harness clamp bolt and reposition.
    6. IMPORTANT: The clamp for the air intake pipe uses reverse threads.
    Fig 1: Removing Turbocharger Air Intake Pipe
    GM1394901Courtesy of GENERAL MOTORS CORP.
  6. Loosen the air intake pipe to turbocharger clamp (1).
  7. Remove the air intake pipe (2) from the turbocharger.
scientia non olet · About LEMON Manuals