LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the mass air flow (MAF)/intake air temperature (IAT) sensor electrical connector (1).
    Fig 1: Disconnecting MAF/IAT Sensor Electrical Connector
    GM877698Courtesy of GENERAL MOTORS CORP.
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  3. Disengage the baffle retainer and remove the baffle.
    Fig 2: Removing Baffle
    GM1602987Courtesy of GENERAL MOTORS CORP.
  4. Grasp the air cleaner assembly and pull up on the assembly in order to disengage the retaining pins from the grommets.
    Fig 3: Removing Air Cleaner Assembly
    GM1602988Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals