LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Line up the retaining pins with the grommets.
    Fig 1: Installing Air Cleaner Assembly
    GM1602988Courtesy of GENERAL MOTORS CORP.
  2. Install the air cleaner assembly until the air cleaner is seated fully on the mounts and is up against the fender apron.
    3. Fig 2: Installing Baffle
    GM1602987Courtesy of GENERAL MOTORS CORP.
  3. Install the baffle and engage the baffle retainer.
  4. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  5. Connect the MAF/IAT sensor electrical connector (1).
    Fig 3: MAF/IAT Sensor Electrical Connector
    GM877698Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals