LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal with Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Position the accelerator pedal to the accelerator pedal bracket.
    Fig 1: Installing Accelerator Pedal
    GM1657867Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to Fastener Notice .
  2. Install the accelerator pedal bolts.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  3. Connect the APP sensor electrical connector (1).
    Fig 2: Connecting APP Sensor Electrical Connector
    GM1657866Courtesy of GENERAL MOTORS CORP.
  4. Install the CPA retainer.
  5. Connect a scan tool to the diagnostic port in order to test for proper throttle-opening and throttle-closing range.
  6. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed throttle, and a wide open throttle (WOT).
  7. Verify that the vehicle meets the following conditions:
    • The vehicle is not in a reduced engine power mode.
    • The ignition is ON.
    • The engine is OFF.
  8. Inspect the carpet fit under the accelerator pedal.
scientia non olet · About LEMON Manuals