Removal Procedure
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the left front wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Remove the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) or Front Wheelhouse Liner Replacement - Left Side (GMC) .
- Remove the lower outer bolt (1) from the washer container prior to lowering the vehicle.
- Disconnect the washer pump hoses (1, 2) from the left side fender flange. Refer to Windshield Washer Hose Replacement .
- Drain the windshield washer solvent into a suitable container.
- Disconnect the electrical connectors.
- Lower the vehicle in order to access the hood latch.
- Open the hood.
- Remove the windshield washer solvent cap.
- Remove the auxiliary battery tray, if equipped. Refer to Battery Tray Replacement .
- Remove the upper windshield washer container bolt from under the auxiliary battery tray, if equipped.
- Remove the upper windshield washer solvent container bolts.
- Remove the windshield washer solvent container assembly (2).
IMPORTANT:
Remove the washer container from the underside of the vehicle through the wheelhouse opening.