LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 996 (Wiring Systems And Power Management - Introduction) >> Repair Instructions >> Battery Positive Cable Fuse Replacement (w/Auxiliary Battery) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuse Cover & Connectors
    GM1857176Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the auxiliary battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (w/Single Battery) or Battery Negative Cable Disconnection and Connection (w/Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (w/Dual Batteries) .
  2. Remove the mega fuse cover.
    3. Fig 2: View Of Solenoid Cable Terminal & Nut
    GM1857420Courtesy of GENERAL MOTORS CORP.
  3. Remove the starter solenoid cable nut (1) from the fuse stud.
  4. Remove the starter solenoid cable terminal (2) from the fuse stud.
    5. Fig 3: View Of Positive Cable Nut, Jumper Cable Terminal & Fuse Nut
    GM1857184Courtesy of GENERAL MOTORS CORP.
  5. Remove the auxiliary battery positive cable nut (1) from the mega fuse holder.
  6. Remove the generator battery jumper cable to fuse nut (3).
  7. Remove the generator battery jumper cable terminal (2) from the fuse stud.
  8. Remove the auxiliary battery positive cable from the fuse studs.
    9. Fig 4: View Of Mega Fuse & Nut
    GM1857459Courtesy of GENERAL MOTORS CORP.
  9. Remove the upper mega fuse nut (1), if necessary.
  10. Remove the appropriate mega fuse (2).
scientia non olet · About LEMON Manuals