LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 994 (Fixed & MOVEABLE Window Systems) >> Diagnostic Information and Procedures >> DTC B3821 or B3824 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the appropriate rear window switch.
  2. Ignition ON, with the rear window switches enabled, test for more than 10 volts between the control circuit terminal D and ground.
    • If less than the specified range, test the control circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the BCM
  3. If all circuits test normal, replace the rear window switch.
scientia non olet · About LEMON Manuals