LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 985 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> Air Inlet Assembly Replacement

Air Inlet Assembly Replacement

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Air Inlet Assembly & Components
GM1707457Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedure

  1. Remove the HVAC module assembly. Refer to HVAC Module Assembly Replacement .
  2. Disconnect the electrical connector from the recirculation actuator.
1 Recirculation Actuator Screw (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  1.5 N.m (13 lb in)
2 Recirculation Actuator
3 Air Inlet Assembly Screw (Qty: 2)

Tighten:  1.5 N.m (13 lb in)
4 Air Inlet Assembly
Tip:  Tilt the rear of the air inlet assembly upward to release front mounting tabs.
scientia non olet · About LEMON Manuals