Transfer Case Clunk In 4LO

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Transfer Case Clunk in 4LO

Cause	Correction
DEFINITION: During acceleration or deceleration, a clunk is heard or felt in the transfer case while in the 4LO range only. Review the Symptoms - Transfer Case and perform the necessary inspections.
High/low planetary carrier assembly	Inspect for the following conditions: Excessively worn planetary gears The planetary gears loose in the planetary carrier Excessively worn high/low clutch engagement teeth on the carrier Refer to High/Low Planetary Carrier Cleaning and Inspection . Replace the high/low planetary if any of the above conditions are found. Refer to Transfer Case Disassemble and Transfer Case Assemble .
High/low internal gear	Inspect the high/low internal gear to front case fit for excessive looseness. Replace the front case half if the high/low internal gear is loose. Refer to Transfer Case Disassemble and Transfer Case Assemble .
High/low clutch	Inspect the high/low clutch engagement teeth for excessive wear. Inspect the high/low clutch to rear output shaft splines for excessive wear. Replace the high/low clutch if faulty. Refer to Transfer Case Disassemble and Transfer Case Assemble .