LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 908 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Mount Replacement - Right Side (2500 LY6) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount
    GM1701903Courtesy of GENERAL MOTORS COMPANY
  1. Position the engine mount to the engine.
    2. Fig 2: View Of Engine Mount To Engine Bolts
    GM1701900Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

    Fig 3: Locating Tab On Engine Block
    GM1963125Courtesy of GENERAL MOTORS COMPANY
  2. Install the two top engine mount to engine bolts (1).

    Tighten the bolts to 50 N.m (37 lb ft). 

  3. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
  4. Remove the adjustable jack from the engine block lifting tab (1).
    Fig 4: View Of Engine Mount To Frame Bolts
    GM1701898Courtesy of GENERAL MOTORS COMPANY
  5. Install the engine mount to frame bolts (1).

    Tighten bolts to 65 N.m (48 lb ft)  starting with the middle bolt then either side bolt.

  6. Install the starter motor. Refer to Starter Replacement .
    Fig 5: View Of Engine Mount To Engine Bolts
    GM1701900Courtesy of GENERAL MOTORS COMPANY
  7. Install the two lower engine mount to engine bolts (1).

    Tighten the bolts to 50 N.m (37 lb ft). 

  8. Install the upper intake manifold sight shield. Refer to Upper Intake Manifold Cover Replacement 
scientia non olet · About LEMON Manuals