Removal Procedure
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the rear axle. Refer to Rear Axle Replacement (15/25 Series) or Rear Axle Replacement (15 Series with Drum Brakes) or Rear Axle Replacement (35 Series) .
- Remove the rear axle cover housing and gasket. Refer to Rear Axle Housing Cover and Gasket Replacement .
- Remove the axle shafts. Refer to Rear Axle Shaft Replacement (8.6, 9.5/9.5LD Inch Axles) or Rear Axle Shaft Replacement (8.6 Inch Axle w/Drum Brakes) .
- Remove the rear brake assembly bolts.
- Remove the rear brake assemblies.
- Remove the rear axle shaft oil seals and bearings. Refer to Rear Axle Shaft Seal and/or Bearing Replacement (w/Rear Disc) or Rear Axle Shaft Seal and/or Bearing Replacement (w/Rear Drum) .
- Remove the drive pinion shaft yoke and oil seal. Refer to Drive Pinion Flange/Yoke and/or Oil Seal Replacement (All Except 9.75 Inch Axle) or Drive Pinion Flange/Yoke and/or Oil Seal Replacement (8.6 Inch Axle w/Drum Brakes) .
- Remove the differential assembly. Refer to Drive Pinion and Ring Gear Replacement (8.6, 9.5/9.5LD, and 11.5 Inch Axles) or Drive Pinion and Ring Gear Replacement (10.5 Inch Axle) .
- Remove the drive pinion and the inner pinion bearing. Refer to Drive Pinion and Ring Gear Replacement (8.6, 9.5/9.5LD, and 11.5 Inch Axles) or Drive Pinion and Ring Gear Replacement (10.5 Inch Axle) .
- Remove the pinion bearing cups. Refer to Drive Pinion Bearings Replacement (8.6, 9.5/9.5LD, and 11.5 Inch Axles) .