Circuit/System Testing

1. Ignition OFF, connect a test lamp between the HORN fuse test point and ground.
2. Press and release the horn pad. The test lamp should turn ON and OFF when changing between the commanded states.
   • If the test lamp does not illuminate or remains illuminated at all times, refer to Horn Switch Circuit Test below.
3. Ignition ON, command the horn ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
   • If the test lamp does not illuminate, test the control circuit terminal 18 at the BCM harness connector C5 for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
4. Connect a 15A fused jumper wire between the HORN fuse test point and B+. The horn should sound and emit a clear and even tone.
   • If the horn does not sound, refer to Horn Circuit Test below.
   • If the sound emitted is not clear and even, refer to Horn - Poor Tone below.

Horn Switch Circuit Test

1. Ignition OFF, disconnect the harness connector at the horn switch.
2. Ignition OFF, test for less than 1.0 ohm of resistance between the ground circuit terminal B and ground.
   • If greater than the specified range, test the ground circuit for and open/high resistance.
3. Connect the harness connector at the horn switch.
4. Disconnect the harness connector C4 at the underhood fuse block.
5. Connect a test lamp between the control circuit terminal G1 and B+.
6. Press and release the horn pad. The test lamp should turn ON and OFF when changing between the commanded states.
   • If the test lamp is always ON, test the control circuit for a short to ground or a sticking horn pad/switch. If the circuit tests normal, replace the BCM.
   • If the test lamp is always OFF, test the control circuit for a short to voltage, an open high resistance, or a horn switch which is not closing.
7. Ignition OFF, connect the harness connector at the underhood fuse block. Disconnect the harness connector at the horn.
8. Verify that a test lamp does not illuminate between the control circuit terminal B and ground.
   • If the test lamp illuminates, test the control circuit for a short to voltage. If the circuit tests normal, replace the underhood fuse block.
9. If all circuits test normal, test or replace the underhood fuse block.

Horn Circuit Test

1. Ignition OFF, disconnect the harness connector at the horn.
2. Ignition OFF, test for less than 1.0 ohm of resistance between the ground circuit terminal A and ground.
   • If greater than the specified range, test the ground circuit for and open/high resistance.
3. Connect a test lamp between the control circuit terminal B and ground.
4. Press and release the horn pad. The test lamp should turn ON and OFF when changing between the commanded states.
   • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the underhood fuse block.
   • If the test lamp is always OFF and the circuit fuse is good, test the control circuit for an open/high resistance. If the circuit tests normal, test or replace the underhood fuse block.
   • If the test lamp is always OFF and the circuit fuse is open, test the control circuit for a short to ground. If the circuit tests normal, test or replace the horn.
5. If all circuit test normal, test or replace the horn.

Horn - Poor Tone

1. Ignition OFF, disconnect the harness connector at the horn.
2. Test for less than 1.0 ohm of resistance between the ground circuit terminal A and ground.
   • If greater than the specified range, test the ground circuit for a high resistance.
3. Disconnect the harness connector C1 at the underhood fuse block.
4. Test for less than 1.0 ohm of resistance between the control circuit terminal E5 at the underhood fuse block and the control circuit terminal B at the horn.
   • If greater than the specified range, test the control circuit for a high resistance.
5. If all circuits test normal, test or replace the horn.