LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 880 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L And 6.2L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Resonator Outlet Duct Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Air Cleaner Outlet Ducts
    GM1696567Courtesy of GENERAL MOTORS CORP.
  1. Install the air cleaner outlet duct to the throttle body and MAF/IAT sensor. Ensure that the resonator tab aligns with the stud on the intake manifold.
  2. Push down on the air cleaner outlet duct resonator directly over the resonator tab in order to secure the resonator to the stud on the intake manifold.
  3. Tighten the air cleaner outlet duct clamp (2) at the throttle body.
    4. NOTE: Refer to Fastener Notice .
  4. Tighten the air cleaner outlet duct clamp (1) at the MAF/IAT sensor.

    Tighten:  Tighten the clamps to 4 N.m (35 lb in).

  5. Install the radiator vent inlet hose retainer to the outlet duct.
  6. Install the radiator inlet hose clamp retainer to the outlet duct.
    7. Fig 2: View Of PCV Tube
    GM1696754Courtesy of GENERAL MOTORS CORP.
  7. Install the PCV line (1) to the air cleaner outlet duct.
  8. Install the intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
scientia non olet · About LEMON Manuals