LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 877 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Current Sensor Replacement (4.8L, 5.3L, 6.0L & 6.2L) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Battery Cable & Current Sensor
    GM1702510Courtesy of GENERAL MOTORS CORP.
  1. Remove the negative battery cable. Refer to Battery Negative Cable Replacement (4.3L)  or Battery Negative Cable Replacement (4.8L, 5.3L, 6.0L, and 6.2L)  or Battery Negative Cable Replacement (6.6L) .
  2. Mark the location of the battery current sensor on the battery cable with tape for reference during installation.
  3. Remove the tape securing the battery current sensor to the negative battery cable.
  4. Mark the location of the negative battery cable clips (1) and remove the clips from the cable.
  5. Squeeze the negative battery cable branches together.
    6. IMPORTANT: Note the orientation of the battery current sensor prior to removal.
  6. Slide the battery current sensor (2) off of the negative battery cable.
scientia non olet · About LEMON Manuals