Front Fender Replacement - Left Side

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Left Fender, Mounting Nuts & Bolts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the headlamp. Refer to Headlamp Replacement (Chevrolet) or Headlamp Replacement (GMC HD) . Remove the front end sheet metal diagonal brace. Refer to Front End Sheet Metal Diagonal Brace Replacement . Remove the front fender rear upper brace. Refer to Front Fender Rear Upper Brace Replacement . Remove the auxiliary battery tray. Refer to Auxiliary Battery Tray Replacement (6.2L, and 6.6L) Remove the left hood hinge. Refer to Hood Hinge Replacement . Remove the left hood link. Refer to Hood Link Replacement . Remove the underhood electrical center/junction block. Refer to Underhood Electrical Center or Junction Block Replacement . Remove the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) or Front Wheelhouse Liner Replacement - Left Side (GMC) .
1	Left Fender Mounting Bolts (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 25 N.m (18 lb ft)
2	Left Fender Mounting Nuts (Qty: 2) Tighten: 25 N.m (18 lb ft)
3	Left Fender Tip: Transfer any necessary additional parts as needed.