LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 866 (Heating, Ventilation, And Air Conditioning) >> Repair Instructions >> HVAC Module Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of HVAC Module, Nuts & Bolts
    GM1698730Courtesy of GENERAL MOTORS CORP.
  1. If replacing the HVAC module, transfer the components from the old HVAC module as necessary.
  2. Install the HVAC module (3).
    3. NOTE: Refer to Fastener Notice .
  3. Install the nuts (2) to the HVAC module (3).

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

  4. Install the bolts (1) to the HVAC module (3).

    Tighten:  Tighten the bolts to 4 N.m (35 lb in).

  5. Connect the electrical harness and the ground connections.
  6. Install the HVAC module drain hose.
  7. Install the instrument panel carrier. Refer to Instrument Panel Carrier Replacement .
  8. Install the upper intake manifold sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
  9. Install the battery. Refer to Battery Replacement .
  10. Install the accumulator. Refer to Accumulator Replacement .
    11. Fig 2: Identifying Heater Hose To Heater Core Fittings
    GM362171Courtesy of GENERAL MOTORS CORP.
  11. Install the surge tank outlet hose to the heater core.

    Firmly push the quick connect onto the heater core pipe until you hear an audible click.

  12. Install the inlet heater hose to the heater core.

    Firmly push the quick connect onto the heater core pipe until you hear an audible click.

  13. Fill the engine coolant. Refer to Cooling System Draining and Filling (Static Fill) or Cooling System Draining and Filling (Vac-N-Fill) .
scientia non olet · About LEMON Manuals