LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 846 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (3 Of 5)) >> Off-Vehicle Repair Instructions (1 Of 3) >> Oil Pump, Screen and Crankshaft Oil Deflector Removal (RPO LY6/L76/L92)

Oil Pump, Screen and Crankshaft Oil Deflector Removal (RPO LY6/L76/L92)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump Screen, Bolt, Nuts, & O-Ring Seal
    GM1277115Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil pump screen bolt (405) and nuts (404).
  2. Remove the oil pump screen (407) with O-ring seal (406).
  3. Remove the O-ring seal from the pump screen.
  4. Discard the O-ring seal.
    5. Fig 2: View Of Crankshaft Oil Deflector
    GM260099Courtesy of GENERAL MOTORS CORP.
  5. Remove the remaining crankshaft oil deflector nuts.
  6. Remove the crankshaft oil deflector.
    7. Fig 3: View Of Oil Pump & Bolts
    GM1658173Courtesy of GENERAL MOTORS CORP.
  7. Remove the oil pump bolts (411).
    8. IMPORTANT: Do not allow dirt or debris to enter the oil pump assembly. Cap ends, as necessary.
  8. Remove the oil pump (413).
scientia non olet · About LEMON Manuals