LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 659 (Transfer Case - NVG 149-NP3 - Service & Troubleshooting) >> Repair Instructions >> Transfer Case Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transfer Case Shield & Bolts
    GM826834Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Position the transfer case shield, if equipped.
  2. Install the transfer case shield bolts, if equipped.

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals