Passenger Door Unlock Operation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

When any of the door lock switches are placed in the unlock position, a ground signal is applied to the BCM through the door unlock signal circuit. Upon receiving this signal, the BCM grounds the control side of the passenger door unlock relay through the door unlock relay control circuit. Since the other side of the door unlock relay winding is connected to battery voltage, the relay is energized. This causes the contacts to close and complete the path from the DOOR LKS fuse through the battery voltage circuit. Voltage is then applied to the unlock side of the passenger door lock actuators through the door lock actuator unlock control circuits. Since the other side of the door lock actuators are connected to the normally closed contacts of the door lock relay to ground, the passenger doors unlock.

The door unlock function can also be accomplished by the BCM supplying ground to the passenger door unlock relay control circuit during a keyless entry unlock transmission.