LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 245 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Knee Bolster Bracket Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the inner and outer knee bolster brackets (2) to the I/P.
    CAUTION: Refer to FASTENER NOTICE .
  2. Install the nuts (1).

    Tighten 

    Tighten the nuts to 10 N.m (88 lb in).

    Fig 1: Installing Knee Bolster Brackets - Left
    G02422651Courtesy of GENERAL MOTORS CORP.
  3. Install the knee bolster (1) to the knee bolster brackets.
  4. Install the nuts (2).

    Tighten 

    Tighten the nuts to 10 N.m (88 lb in).

  5. Install the knee bolster trim panel. Refer to Knee Bolster Replacement - Left .
    Fig 2: Installing Knee Bolster - Left
    G02422652Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals