Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rear servo assembly to the transmission case as follows:
- Accumulator spring (14)
- Selective pin (13)
- Servo spring retainer (12)
- Servo spring (11)
- Washer (10)
- Piston seal (9)
- Accumulator piston (8)
- Inner ring oil seal (7)
- Outer ring oil seal (1)
- Servo piston (2)
- Bottom retaining clip (3)
- Cover gasket (4)
- Cover (5)
- Cover Bolt (6)
CAUTION: Refer to FASTENER NOTICE . - Install the cover bolts (6).
Tighten
Tighten the bolts to 24 N.m (18 lb ft).
- Install the transmission oil pan and filter. Refer to Automatic Transmission Fluid/Filter Replacement .
- Lower the vehicle.
- Fill the transmission to the proper level with Dexron® III transmission fluid. Refer to Transmission Fluid Checking Procedure .