LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 234 (Seat System) >> Repair Instructions >> Seat Back Hinge/Recliner Mechanism Replace - Front >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the hinge/recliner mechanism (6) to the seat assembly.
    CAUTION: Refer to FASTENER NOTICE .
  2. Install the bolts (2,8) to retain the hinge/recliner mechanism (6) to the seat back frame.

    Tighten 

    Tighten the bolts to 32 N.m (24 lb ft).

  3. Install the bolts (3,7) to retain the hinge/recliner mechanism (6) to the seat cushion frame.

    Tighten 

    Tighten the bolts to 32 N.m (24 lb ft).

    4. Fig 1: Removing Front Seat Back Hinge/Recliner Mechanism
    G02423285Courtesy of GENERAL MOTORS CORP.
  4. Install the front seat back cover. Refer to Seat Back Cover and Pad Replacement - Front .
  5. Install the front seat cushion cover. Refer to Seat Cushion Cover and Pad Replacement - Front .
  6. Install the seat back recliner handle if recliner mechanism was removed. Refer to Seat Back Recliner Handle Replacement - Front .
  7. Install the seat to the vehicle. Refer to Seat Replacement .
scientia non olet · About LEMON Manuals