LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 234 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using hot melt glue or equivalent, glue the seat back foam pad onto the seat back frame.
  2. Working from side to side, install the seat back cover (1) over the foam pad (2).
  3. Install the armrest to the seat back. Refer to Armrest Replacement - Front Seat .
  4. Engage the hook and loop strips in order to retain the seat back cover (1) to the seat back foam pad (2).
  5. Engage the J. channel retainer at the bottom edge of the seat back cover (1).
  6. Install the assist handle if equipped. Refer to Assist Handle Replacement .
    Fig 1: Installing Front Seat Back Cover & Pad
    G02423281Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals