Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- If replacing the lower inner shaft housing bushing, install the inner shaft housing bore into a vise.
- Place the lower inner shaft housing bushing over the bushing bore.
- Install the J-45850-2 (2), J-45850-1 (3), the forcing screw, the thrust bearing, the washers, and the nuts (1) over the inner shaft housing bushing as shown.
Install the J-45850-3 inside the J-45850-2 (2) in order to gain access to the upper nut.
- Install the lower inner shaft bushing by holding the lower nut and slowly tightening the upper nut in order to pull the bushing into the bushing bore.
- If replacing the upper inner shaft housing bushing, install the inner shaft housing bushing bore into a vise.
- Place the upper inner shaft housing bushing over the bushing bore.
- Install the J-45850-2 (2), J-45850-2 (2) in order to gain access to the upper nut.
- Install the upper inner shaft bushing by holding the lower nut and slowly tightening the upper nut in order to pull the bushing into the bushing bore.
- Remove the inner shaft housing from the vise.
- Install the inner shaft housing. Refer to Inner Shaft and/or Housing Replacement - Front Drive Axle .