Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- If replacing the lower differential carrier assembly bushing, install the bushing by performing the following steps:
- Install the differential carrier assembly bushing into the differential carrier assembly bushing bore.
- Install the J-45850-2 (3), the J-45850-3 (2), the forcing screw, the thrust bearing, and the nuts (1, 4-5) over the differential carrier assembly bushing as shown.
- Install the lower differential carrier assembly bushing by holding the upper nut and tightening the lower nut to the J-45850.
- If replacing the upper differential carrier assembly bushing, install the bushing by performing the following steps:
- Install the differential carrier assembly bushing into the differential carrier assembly bushing bore.
- Install the J-45850-2 (2), the J-45850-3 (3), the forcing screw, the thrust bearing, the washers, and the nuts (1) over the differential carrier assembly bushing as shown.
- Install the upper differential carrier assembly bushing by holding the lower nut and tightening the upper nut of the J-45850.
- Install the differential carrier assembly. Once the differential carrier assembly is installed, remove the piece of tape in order to connect the vent hose. Refer to Differential Carrier Assembly Replacement .