LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Compressor Oil Balancing >> Draining Procedure

Draining Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Important  : Drain and measure as much of the refrigerant oil as possible from the removed compressor.

  1. Drain the oil from both the suction and discharge ports of the removed compressor into a clean, graduated container.

    Rotate the compressor shaft to assist in draining the compressor.

  2. Measure and record the amount of oil drained from the removed compressor.

    This measurement will be used during installation of the replacement compressor.

  3. Properly discard the used refrigerant oil.
    Fig 1: Draining Oil From Suction & Discharge Ports Of Compressor
    G01216893Courtesy of GENERAL MOTORS CORP.