LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 222 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fan cage (2) to the blower motor (3).
  2. Install the retaining clip to the fan cage (2).
  3. Install the blower motor.
    Fig 1: Installing Fan Cage & Retaining Clip
    G01216965Courtesy of GENERAL MOTORS CORP.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  4. Install the blower motor retaining screws (1).

    Tighten 

    Tighten the screws to 2 N.m (18 lb in).

  5. Install the blower motor cooling tube (3).
  6. Connect the blower motor electrical connector (2).
    Fig 2: Installing Blower Motor Retaining Screws & Cooling Tube & Connecting Electrical Connector
    G01216966Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals