LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Wheel Control Switch Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to ZONE 3 .
  2. Remove the inflator module. Refer to REMOVAL & INSTALLATION (DRIVER-SIDE) .
  3. Disconnect the steering wheel control electrical connector.
  4. Remove the steering wheel nut.
  5. Install J-42578 and J-1859-A to the steering wheel.
    Fig 1: Installing J-42578 & J-1859-A To Steering Wheel
    G01217382Courtesy of GENERAL MOTORS CORP.
  6. Use J-42578 and J-1859-A in order to remove the steering wheel.
  7. Remove J-42578 and J-1859-A from the steering wheel.
  8. Remove the controls and the control harness from the steering wheel.
scientia non olet · About LEMON Manuals