LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Tilt Head Housing Replacement (Tilt) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the tilt head onto the steering shaft.
  2. Install the tilt head housing and steering shaft as an assembly. Refer to Lower Bearing and Steering Column Jacket Replacement (Column Shift Tilt)  or Lower Bearing and Steering Column Jacket Replacement (Column Shift Standard)  .

    Important  : The switch mounting bracket must be pressed firmly against the steering column tilt head.

  3. Slide the turn signal switch housing onto the steering column shaft assembly.
  4. Install the turn signal and multifunction switch assembly only. Refer to Multifunction, Turn Signal Switch Replacement .
  5. Install the turn signal cancel cam assembly. Refer to Turn Signal Cancel Cam and Upper Bearing Thrust Washer .
  6. Enable the SIR system. Refer to ZONE 3 .
    Fig 1: Installing Tilt Head Onto Steering Shaft
    G01217394Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals