LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Steering Wheel & Steering Column) >> Repair Instructions >> Horn Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to DISABLING SYSTEM .
  2. Remove the inflator module. Refer to REMOVAL & INSTALLATION (DRIVER-SIDE) .
  3. Remove the horn plunger from the steering column by pressing inward to the stop and rotating horn plunger 90 degrees.
    Fig 1: Removing Horn Plunger From Steering Column
    G01217378Courtesy of GENERAL MOTORS CORP.
  4. Remove the horn contact plate retaining screws from the steering wheel.
  5. Remove the horn plunger from the steering wheel.
    Fig 2: Removing Horn Plunger From Steering Wheel
    G01217379Courtesy of GENERAL MOTORS CORP.