LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement (GT5) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install drain pan under the vehicle.
  2. Raise and support the vehicle.
  3. Disconnect the power steering cooler hose from the power steering pump.
  4. Disconnect the power steering cooler hose from the power steering gear.
  5. Cap the power steering pipes and cooler ends in order to prevent the entry of dirt.
  6. Remove the power steering cooler mounting nuts.
  7. Remove the power steering cooler from the vehicle.
    Fig 1: Removing Power Steering Cooler
    G01217139Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals