LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement (GT5) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power steering cooler to the vehicle.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the power steering cooler mounting nuts.

    Tighten 

    Tighten the nuts to 28 N.m (21 lb ft).

  3. Connect the power steering cooler hose to the power steering gear.

    Tighten 

    Tighten the hose fitting to 33 N.m (24 lb ft).

  4. Connect the power steering cooler hose to the power steering pump.
  5. Lower the vehicle.
  6. Bleed the power steering system. Refer to Bleeding the Power Steering System .
  7. Remove the drain pan from under the vehicle.
    Fig 1: Installing Power Steering Cooler
    G01217140Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals