LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (Power Steering System) >> Repair Instructions >> Power Brake Booster Inlet Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a drain pan under the vehicle.
  2. Siphon the power steering fluid from the reservoir to prevent excessive spillage.
  3. Raise and support the vehicle.
  4. Remove the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  5. Remove the power brake booster inlet hose (2) from the power steering pump (1) through the wheelwell.
  6. Lower the vehicle.
    Fig 1: Removing Power Brake Booster Inlet Hose From Power Steering Pump
    G01217147Courtesy of GENERAL MOTORS CORP.
  7. Remove the power brake booster inlet hose (1) from the power brake booster (2).
  8. Remove the power brake booster inlet hose from the vehicle.
    Fig 2: Removing Power Brake Booster Inlet Hose From Power Brake Booster
    G01217148Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals