Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Install the spare tire hoist into the slot in the rear crossmember.

Fig 1: Installing Spare Tire Hoist Into Rear Crossmember Slot
Courtesy of GENERAL MOTORS CORP.

NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Install the spare tire hoist retaining bolt.
Tighten

Tighten the bolt to 52 N.m (38 lb ft).

Fig 2: Installing Spare Tire Hoist Retaining Bolt
Courtesy of GENERAL MOTORS CORP.
Install the guide shaft to the vehicle, then to the hoist. Ensure that the hole for the retaining pin in the guide shaft and the hoist are aligned.

Fig 3: Installing Guide Shaft To Vehicle
Courtesy of GENERAL MOTORS CORP.
Install the guide shaft retaining pin.

Fig 4: Installing Guide Shaft Retaining Pin
Courtesy of GENERAL MOTORS CORP.
Install the guide shaft retaining pin clip.
Remove the safety stands and lower the vehicle.
Install the spare tire to the hoist and raise it into position.

Fig 5: Installing Guide Shaft Retaining Pin Clip
Courtesy of GENERAL MOTORS CORP.