LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 208 (Starting System) >> Repair Instructions >> Starter Motor Replacement (4.8L, 5.3L & 6.0L) >> Installation

Starter Motor Replacement (4.8L, 5.3L & 6.0L): Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. If necessary, install the starter shield. See Figure.
  2. Snap the transmission cover to the starter. See Figure.
  3. Install the positive cable to the starter stud. See Figure. Install the starter lead nut. Tighten the starter lead nut to specification. See FASTENER TIGHTENING SPECIFICATIONS .
  4. Install the starter solenoid lead to the solenoid stud. Install the starter solenoid nut. Tighten the starter solenoid nut to specification. See FASTENER TIGHTENING SPECIFICATIONS .
  5. Slide the starter rearward. See Figure. Install the starter bolts. Tighten the starter bolts to specification. See FASTENER TIGHTENING SPECIFICATIONS .
  6. Connect the oil level sensor electrical connector.
  7. Install the right transmission cover bolt. See Figure. Tighten the transmission cover bolt to specification. See FASTENER TIGHTENING SPECIFICATIONS .
  8. Lower the vehicle. Connect the negative battery cable. Tighten to specification. See FASTENER TIGHTENING SPECIFICATIONS .
scientia non olet · About LEMON Manuals