3-5 Reverse Clutch Housing Inspection Assembled

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inspecting 3-5 Reverse Clutch Housing

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	1-2-3-4 and 3-5 Reverse Clutch Housing Assembly Procedure Apply soap compound to weld area of housing. Hold thumb over the air bleed passage. For fully assembled 1-2-3-4 and 3-5 reverse clutch housing spray compressed air into the 3-5R clutch feed hole and inspect weld area for bubbles. If bubbles are detected a new housing is required.

Callout

Component Name

1-2-3-4 and 3-5 Reverse Clutch Housing Assembly

Procedure

Apply soap compound to weld area of housing.
Hold thumb over the air bleed passage.
For fully assembled 1-2-3-4 and 3-5 reverse clutch housing spray compressed air into the 3-5R clutch feed hole and inspect weld area for bubbles.
If bubbles are detected a new housing is required.