LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1802 (Transfer Case - Mp 3023/3024-NQH) >> Repair Instructions - Off Vehicle >> Transfer Case Disassemble >> Rear Output Shaft Seal and Bushing Removal

Rear Output Shaft Seal and Bushing Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Output Shaft Seal And Bushing
GM1849345Courtesy of GENERAL MOTORS CORP.
Rear Output Shaft Seal and Bushing Removal

Callout Component Name
1 Transfer Case Rear Output Shaft Seal
CAUTION:

Refer to Transfer Case Seal Removal Caution .
2 Transfer Case Rear Output Shaft Bushing
The following procedure is for the light duty application, for the heavy duty and super heavy duty applications. Refer to Rear Output Shaft Bushing Replacement .
Follow the steps below for use of the J 45380  remover/installer.

Procedure

  1. Install the finger section of the J 45380  remover/installer in front of the bushing.
  2. Install the tube and forcing screw assembly into the finger section. Ensure the forcing screw is backed out.
  3. Using a wrench on the forcing screw, remove the bushing.

TIP:  Only remove the bushing if faulty. Refer to Transfer Case Rear Half Cleaning and Inspection .
Special Tools 
J 45380  Transfer Case Rear Bushing Remover and Installer
scientia non olet · About LEMON Manuals