Circuit/System Testing
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Perform the Line Pressure Check
. Verify the transmission line pressures are within the specified ranges.
- If not within the specified ranges, refer to Fluid Pressure High or Low .
- Ignition OFF, remove the Q8 control solenoid valve assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly Replacement .
- Perform the Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test
. Test all solenoids on the Q8 control solenoid valve assembly. A pressure change should occur for each solenoid valve.
- If the Q8 control solenoid valve assembly does not pass the performance test, replace the Q8 control solenoid valve assembly.
- Listed in the chart below, are conditions for each component that could set DTC P0796 or P0797. Carefully inspect each component for that condition. Repair or replace as necessary.
| DTC | Component | Condition |
|---|---|---|
| P0796 P0797 |
Control Valve Upper Body Assembly (304) | 4-5-6 Regulator Valve (327) stuck / sticking - debris, binding, damaged valve, or scored bore |
| P0796 | 4-5-6 Clutch Housing Assembly (441) | Turbine Shaft Seals (442) damaged or leaking |
| P0796 P0797 |
Q8 Control Solenoid Valve Assembly (314) |
|
| P0796 P0797 |
Control Valve Lower Body Assembly (307) | Clutch select valve (352) stuck / sticking - debris, binding, damaged valve, or scored bore |
| P0796 | 4-5-6 Clutch Housing Assembly (441) | 4-5-6 Clutch Piston Assembly (439) damaged / leaking |
| P0796 | Transmission Cooling / Lubrication |
|
| P0796 | Torque Converter (w/Fluid Pump) Housing Assembly (2) |
|
| P0796 | 4-5-6 Hub / Shaft Assembly (58) | 4-5-6 Hub / Shaft - broken hub weld |
| P0796 | Automatic Transmission Fluid Filter Assembly (26) | Oil filter (26) or filter seal (25) loose or damaged |
| P0796 | 1-2-3-4 and 3-5-R Clutch Housing Assembly (51) | 1-2-3-4 Clutch Backing Plate Retaining Ring (429) not seated / oriented, causing clutch pack / piston over travel |
| P0796 | Control (with body and valve) Valve Assembly (21) | Valve Body to Pump Transfer Seal Assembly (18) damaged / leaking |