Torque Converter Installation

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

J 21366: Converter Holding Strap

Fig 1: View Of J 21366 Installed On Torque Converter

Courtesy of GENERAL MOTORS CORP.

WARNING: The torque converter weighs approximately 65 lbs. Personal injury may result if you lift the torque converter improperly.

CAUTION: Make sure that the torque converter remains installed all the way into the pump, when bolting the transmission to the engine. Damage to the pump may occur if not installed correctly.

Install the torque converter.
Install the J 21366: converter holding strap.