Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

J 7004-A: Universal Remover
J 8092: Driver Handle
J 25019: Bushing Service Set
J 34196-B: Transmission Bushing Service Set

Fig 1: Inspection Areas On Reverse Input Clutch Housing & Drum Assembly

Courtesy of GENERAL MOTORS CORP.

Inspect the reverse input clutch housing and drum assembly for the following conditions:
- Damaged or worn bushings
- Surface finish on the hub and outer housing - check band surface for flatness
- Leak at the weld
- Heat distortion
- Rolled or distorted retaining ring groove

Fig 2: Removing Reverse Input Clutch Front Bushing

Courtesy of GENERAL MOTORS CORP.

Using the J 25019-16 which is part of J 25019: bushing service set with the J 7004-A: remover, remove the reverse input clutch front bushing (603).

Fig 3: Removing Reverse Input Clutch Rear Bushing

Courtesy of GENERAL MOTORS CORP.

Using the J 25019-4 which is part of J 25019: bushing service set with the J 8092: driver handle, remove the reverse input clutch rear bushing (606).