Output Shaft Installation

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

J 29837-A: Output Shaft Support Fixture

Fig 1: Installing Output Shaft

Courtesy of GENERAL MOTORS CORP.

NOTE: It is important to note that the input shaft may need a light tap to fully seat into position. If the input shaft is not completely engaged, the output shaft to input carrier retainer (661) will not seat.

Install the output shaft (687).

Fig 2: Supporting Output Shaft

Courtesy of GENERAL MOTORS CORP.

Install the J 29837-A: support fixture as shown. Support the output shaft (687) with adjustable stop (1).