Installation Procedure
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install NEW O-ring seals onto the oil level indicator tube.
- Lightly lubricate the O-ring seals with engine oil.
- Install the oil level indicator tube.CAUTION: Refer to Fastener Caution .
- Install the oil level indicator tube bolt at the indicator tube bracket.
Tighten: Tighten the bolt to 21 N.m (15 lb ft).
- Install the starter motor. Refer to Starter Replacement (V8) or Starter Replacement (V6) or Starter Replacement (6.6L) .
- Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (V8) or Exhaust Manifold Replacement - Right Side (6.6L) or Exhaust Manifold Replacement - Right Side (V6) .
- Install the oil level indicator.