LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1680 (Engine Mechanical - 6.6L (LMM) - Repair Instructions - On Vehicle) >> Crankshaft Front Oil Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Pressing Crankshaft Front Oil Seal On Using J 44645
    GM663819Courtesy of GENERAL MOTORS CORP.
  1. Clean the front crankshaft seal bore and the crankshaft.
  2. Lubricate the crankshaft sealing surface with clean engine oil.
  3. Place the crankshaft front oil seal onto the crankshaft.
  4. Install J 44645  to the crankshaft. See Special Tools .
  5. Press the crankshaft front oil seal onto the crankshaft using J 44645  until the tool bottoms out. See Special Tools .
  6. Remove J 44645  . See Special Tools .
  7. Install the crankshaft balancer. Refer to Crankshaft Balancer Replacement .
scientia non olet · About LEMON Manuals