LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1671 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L - Repair Instructions - Off Vehicle (3 Of 3)) >> Clutch Pilot Bearing Installation

Clutch Pilot Bearing Installation

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

    Fig 1: Seating Bearing In Bore Of Crankshaft
    GM2187976Courtesy of GENERAL MOTORS CORP.
  1. Position the bearing to the rear of the crankshaft.
  2. Assemble the J 8433:  two jaw puller (2), the J 45949:  pilot bearing and flywheel locator installer (1) and bolts to the rear of the crankshaft.

    Tighten the bolts until snug.

  3. Rotate the bolt of the J 8433:  two jaw puller (2) until the bearing is seated in the bore of the crankshaft.
  4. Remove the tools.
    5. Fig 2: Locating Clutch Pilot Bearing
    GM63195Courtesy of GENERAL MOTORS CORP.
  5. Inspect the clutch pilot bearing for proper installation.
scientia non olet · About LEMON Manuals