LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1634 (Steering Linkage) >> Repair Instructions >> Steering Linkage Inner Tie Rod Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove all traces of oil, grease, or other contaminants.
  2. Clean the threads of the steering linkage inner tie rod with denatured alcohol or the equivalent and allow to dry.
  3. Apply red LOCTITE™ threadlocker, GM P/N 12345493 (Canadian P/N 10953488) to the threads of the steering linkage inner tie rod.
    4. Fig 1: Removing/Installing Inner Tie Rod End
    GM865341Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  4. Install the steering linkage inner tie rod (1) to the relay rod using wrench J 34028  (2) and tighten to 100 N. See Special Tools .m (74 lb ft).
  5. Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
  6. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
  7. Adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .
scientia non olet · About LEMON Manuals