LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1629 (Engine Mechanical - Hybrid (Hp2) 6.0L (LZ1)) >> Repair Instructions - On Vehicle >> Drive Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Drive Belt Idler Pulley
    GM1959938Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt idler pulley (2) and bolt to the generator bracket.

    Snug the bolt finger tight.

    2. CAUTION: Refer to Fastener Caution .
  2. Tighten the drive belt idler pulley bolt (1).

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  3. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals